| Onderdelen: Diversen | NIEUW Bewegingssensor voor de hobbyist... Nu binnen... E 3                       6044

NIEUW Bewegingssensor voor de hobbyist... Nu binnen... E 3

NIEUW Bewegingssensor voor de hobbyist... Nu binnen... E 3

Weer een leuk nieuw product voor de hobbyist... Zelf solderen... Check youtube! Nu ter introductie tot en met 16 januari geen E 4 maar E 3 per stuk!!

2014 Portable PIR Motion Sensor Detector Module Adjust IR Pyroelectric

It is great for microcontrollers such as arduino for funduino and many more including the rasberry pi!

It is a Sensor Module with an operating voltage of 5v to 20v
Operating voltage. It has a high value of 3.3 volts and a low of 0 (it is either on or off). Its delay time can be adjusted from 5 to 200 seconds as well as the sensing range from 3 meter to 7 meters. The entire sensor with the board is 32mm by 24mm (standard pir motion sensor). The sensor either gives off a 3.3 volt high value when motion is detected and then resumes or continues to give off a 0 voltage when no motion is detected. If you use an arduino or other micro controllers you can use the 3.3 volt out to power the sensor or use the 5volt power pin (vcc) to power the sensor. Either one will work.

Working voltage range: DC 4.5-20V
Static current: <50uA
High level output: 3.3 V / low 0V
Trigger mode: L unrepeatable trigger /H repeated trigger (Default Repeating trigger)
Delay time: 0.5-200S (adjustable) can be produced range 0.1 seconds - a few minutes
Blocking time: 2.5S (the default) can be produced range 0.1 seconds, tens of seconds
Size: 32mm*24mm circuit board
Induction angle: <100 degree cone angle
Working temperature: -15-+70 degrees
Induction of lens size: diameter: 23mm (default)

Prijs: € 3

Home Informatie Account Winkelwagen - De voordeligste computers van Nederland